Truss Rod Issues
Moderators: rickenbrother, ajish4
- FretlessOnly
- Advanced Member
- Posts: 1605
- Joined: Sat Feb 21, 2009 9:00 pm
Re: Truss Rod Issues
OK, I did mean front to back, so your response suggests that there is a correct way and an incorrect way to insert the rods with respect to the fingerboard and the rod channel (forget the headstock vs. the body end; I've got that one). How are they inserted? What features of the rods face the fingerboard and what features set down in the channel? THis way, I'll know if when I removem them whether they go back in the same way or the opposite way?
Can we have everything louder than everything else?
- jingle_jangle
- RRF Moderator
- Posts: 22679
- Joined: Wed Dec 22, 2004 6:00 am
- Contact:
Re: Truss Rod Issues
Oh, the arc should be high in the center, not low (frowning instead of smiling). And, in the case of the old style folded rods, the threaded longer ends go on the bottom.
- FretlessOnly
- Advanced Member
- Posts: 1605
- Joined: Sat Feb 21, 2009 9:00 pm
Re: Truss Rod Issues
Ah, thanks Paul. Mine's a 2008. But the frown image works; and this would be why fingerboards on the 4001 sometimes sustained damge when adjusted inproperly. The arc pushed up on the fingerboard. Makes sense to me.
Can we have everything louder than everything else?
- rickenbrother
- RRF Moderator
- Posts: 13099
- Joined: Sun May 26, 2002 5:00 am
Re: Truss Rod Issues
4001 trussrod removal direction:
The JETGLO finish name should be officially changed to JETGLO ROCKS!
- bassmekanik
- New member
- Posts: 49
- Joined: Tue Feb 03, 2009 2:33 pm
Re: Truss Rod Issues
Nice pic joey. Shows quite clearly the way to remove them.
Not going to have time to do it this weekend. I`ll let you know how i get on once i get my finger out!!
Not going to have time to do it this weekend. I`ll let you know how i get on once i get my finger out!!
Re: Truss Rod Issues
I have heard it's a good idea to clamp the finger board to the neck during the operation... any merit to this?
- rickenbrother
- RRF Moderator
- Posts: 13099
- Joined: Sun May 26, 2002 5:00 am
Re: Truss Rod Issues
Yes, especially if in some cases with 4001 truss rods you have to pry up on the nuts to straighten out the end of the rods.ram wrote:I have heard it's a good idea to clamp the finger board to the neck during the operation... any merit to this?
The JETGLO finish name should be officially changed to JETGLO ROCKS!