Page 3 of 3
Re: How to install an HB1 on a 4003?
Posted: Tue Jul 04, 2017 1:27 am
by jps
I mounted a toaster pickup in the bridge position of my old 4003FL in 2004, along with a few other mods. I don't recall how difficult it was to remove the hi-gain pickup from the mounting plate, though.
Re: How to install an HB1 on a 4003?
Posted: Fri Jul 07, 2017 6:09 pm
by rickenbastard
Put an actual ace of spades in the bridge position cover. Neck is overwound to imitate an EB-0.
Re: How to install an HB1 on a 4003?
Posted: Tue Jul 25, 2017 3:33 am
by badmanoakland
Does anyone have one or two HB1s for sale?
I can't find any for less than $160. I'd really like to try one in my '76 4001.
Re: How to install an HB1 on a 4003?
Posted: Tue Jul 25, 2017 10:48 am
by aceonbass
Just sent you an email Conrad!
Re: How to install an HB1 on a 4003?
Posted: Tue Jul 25, 2017 7:19 pm
by badmanoakland
aceonbass wrote:Just sent you an email Conrad!
Hey, didn't get an email Yet, checked my junk box too. Can you send me a PM?
Re: How to install an HB1 on a 4003?
Posted: Sat Mar 02, 2019 12:28 pm
by berth
aceonbass wrote:The red wire goes to the switch, and the blue/shield wires go to the back of the pot. I seem to have an extra HB1 in stock too...
Thanx Dane! This stopped the noise which was coming out of my 4000 after having soldered an HB-1 into it.
