Hipshot Ultralights tuner wing/neck joint install question
Moderators: rickenbrother, ajish4
- lumgimfong
- Intermediate Member
- Posts: 704
- Joined: Fri Jan 13, 2017 4:57 pm
Hipshot Ultralights tuner wing/neck joint install question
If the mounting screw screws position falls right on the line where the wing is glued onto the center neck wood, will it be ok to put the screw here into the seam after pilot hole drilled, or will it be bad for the joinery?
Don't want the wing separating from the neck over time.
Anyone installed ultralights on their Ric bass before?
Don't want the wing separating from the neck over time.
Anyone installed ultralights on their Ric bass before?
-
- Junior Member
- Posts: 153
- Joined: Thu Feb 26, 2009 10:59 pm
Re: Hipshot Ultralights tuner wing/neck joint install questi
Michael, if you use the correct size pilot bit it won't be a problem...
Jim
Jim
Re: Hipshot Ultralights tuner wing/neck joint install questi
My experience with UptraLights (my fave tuners) is that the bushing is too short to catch the threads on the tuner body due to the thickness of the headstock. Email Bill at Hipshot customer service and request longer bushings if this is the case.
Re: Hipshot Ultralights tuner wing/neck joint install questi
No worries about mounting Ultralites. Do as you plan to, and yes, order longer bushings from Hipshot, as I did. You will have to slightly ream out the post holes for the Ultralites, again, a simple procedure.
Reaming tool (make sure you get the correct size):
Reaming tool (make sure you get the correct size):
Last edited by jps on Wed Jul 26, 2017 11:12 am, edited 1 time in total.
Re: Hipshot Ultralights tuner wing/neck joint install questi
Yep. Forgot about the tuner holes in the headstock needing to be enlarged to 9/16" via a proper reaming tool. Make sure you purchase the tuners with the 3/8" post size, or you'll need the tool in Jeff's previous post to enlarge the holes...jps wrote: You will have to slightly ream out the post holes for the Ultralites,again, a simple procedure.
- lumgimfong
- Intermediate Member
- Posts: 704
- Joined: Fri Jan 13, 2017 4:57 pm
Re: Hipshot Ultralights tuner wing/neck joint install questi
So I will need the smaller diameter 3/8" set?
Ream if.
Ream if.
Re: Hipshot Ultralights tuner wing/neck joint install questi
Yes. If you really want the larger post version I have a set you can buy; they were on my 4005WB. I have both the cloverleaf and Y keys with them (you can go modern or vintage, easily, and even change them out to suit the gig!lumgimfong wrote:So I will need the smaller diameter 3/8" set?
Re: Hipshot Ultralights tuner wing/neck joint install questi
Either size UltraLights will require reaming. The larger 1/2" post size may interfere with the truss rod cover.lumgimfong wrote:So I will need the smaller diameter 3/8" set? Ream if.