Tech question: '30s potentiometers
Moderators: rickenbrother, ajish4
-
- Junior Member
- Posts: 137
- Joined: Mon Apr 25, 2005 10:25 pm
Tech question: '30s potentiometers
What's the best way to loosen up one of the older potentiometers that you'd find on a mid '30s Ric Bakelite. This is one of the Allen Bradley pots that are about the diameter of a hallf-dollar, much larger than the contemporary ones. It's quite stiff to turn, although it doesn't look rusty or abused. I don't want to risk cracking the knob trying to force it to loosen
I can't find any slot or crevice on it to treat it with electronic cleaner. I want to get it loose enough to do volume swells.
Thanks!
Rob
I can't find any slot or crevice on it to treat it with electronic cleaner. I want to get it loose enough to do volume swells.
Thanks!
Rob
Re: Tech question: '30s potentiometers
Rob, have you tried shooting the cleaner in around the shaft of the pot? No other little slot to try and force some cleaner in through? It's been a while since I've see the AB pots.
Re: Tech question: '30s potentiometers
Try a product call DEOXIT. Get the bottle that has the long stem. Soake the top of the shaft and slowly move it until it frees up. Then do the underside of the pot as well.
Zilla
Zilla
Re: Tech question: '30s potentiometers
I learned a lot about potentiometer repair and care from this thread on the Steel Guitar Forum.
http://bb.steelguitarforum.com/viewtopi ... pot+repair
http://bb.steelguitarforum.com/viewtopi ... pot+repair
- beatlefreak
- Senior Member
- Posts: 6160
- Joined: Wed Jun 14, 2006 5:45 am
- Contact:
Re: Tech question: '30s potentiometers
I'll second that. Make sure you get the kind that contains a lubricant.Zilla wrote:Try a product call DEOXIT.
- jingle_jangle
- RRF Moderator
- Posts: 22679
- Joined: Wed Dec 22, 2004 6:00 am
- Contact:
Re: Tech question: '30s potentiometers
The guys on SGF seem to be down on DeOxit, because they claim it doesn't last. My own best luck with carbon-wiper pots like the ones we're discussing here, has been in taking them apart and after cleaning with denatured alcohol, lubricating with clock oil. It's made for open-backed clocks, so dust attraction is minimized.
Re: Tech question: '30s potentiometers
I'm going with Paul on this one.
Take it apart. Clean it and put it back together.
It just makes sense to me.
Take it apart. Clean it and put it back together.
It just makes sense to me.
-
- Junior Member
- Posts: 137
- Joined: Mon Apr 25, 2005 10:25 pm
Re: Tech question: '30s potentiometers
Richard... Thanks for the advice, I ended up pulling it apart, and was able to get it to rotate a lot smoother. I used an aerosol electronic cleaner with lubricant, and saturated the pot, was able to spray some down the shaft collar, where it appeared to be stuck. The rest of the innards looked almost as clean as the day it was made. It's working a lot better, nice and smooth, but there is a tiny bit of friction still, so I'm going to soak it for a while, and see if it clears up.
Upon closer examination, I think this is possibly a Centrelab as it has a small diamond logo with CR.
Upon closer examination, I think this is possibly a Centrelab as it has a small diamond logo with CR.