Knobs & Nuts

Exploring the beauty and tone of Rickenbacker Lap Steels

Moderators: rickenbrother, ajish4

Knobs & Nuts

Postby (Remark505) » Thu Mar 05, 2015 10:07 pm

Hello All,
I purchased a lap steel not long ago, see my other post here, and needed to replace the control knobs that were incorrect. After much search and no luck I modeled one in Rhino, a very powerful 3-d program. Anyway I then printed it in ABS plastic and while it's not the originals, obviously, they're not bad replications. I also modeled and printed the nut, just in case I needed one down the road. If you need either of these, I'd be happy to either, print them or sending you a copy of the file so that you can print them. I'd only ask that you pay for the time on the printer and shipping, roughly $20.00 and the file, $5.00 to offset a bit of my time, which amounted to roughly 12 hours. I'm not trying to make a profit, just want to assist anyone who may need these, (what was for me) hard to find items.
Best wishes!
Attachments
knobs_s.jpg
saddle_s.jpg
(Remark505)
New member
 
Posts: 3
Joined: Sat Feb 28, 2015 11:25 am

Return to Rickenbacker Steels: by Richard Shatz

Who is online

Users browsing this forum: No registered users and 1 guest