This may have been asked at some other time, but I can't find it if it was so I'll ask anew:
If one wants to remove the upper guard on their 325V59 do they have to use three shorter screws to replace those used to secure the top guard or can those just be screwed farther into the guitar
Thanks----
Bob
325V59 Pickguard
Moderators: rickenbrother, ajish4
Re: 325V59 Pickguard
Check the length of the upper guard screws against the screws in the lower guard. If the upper screws are longer, they will probably bottom out before they are snug.
- beatlefreak
- Senior Member
- Posts: 6160
- Joined: Wed Jun 14, 2006 5:45 am
- Contact:
Re: 325V59 Pickguard
When I removed my upper guard, I just picked up a few screws from Home Depot to replace the longer ones with.
- jingle_jangle
- RRF Moderator
- Posts: 22679
- Joined: Wed Dec 22, 2004 6:00 am
- Contact:
Re: 325V59 Pickguard
They won't bottom out, but they're the wrong size, being #6. However, if you buy the right size (#4 X 3/8 or #4 X 1/2) oval Phillips head screw, they will bottom in the guard, and countersink themselves nicely in the oversized holes from the old screws. Try to find stainless steel screws--they buff up a treat.