RE-HS PU's

by (**teeder**) » Wed Jan 11, 2017 11:17 am

Anyone know what type of magnets are used in the reissue HS's?

Has anyone on here changed them out to experiment with the tone?

by (**jps**) » Wed Jan 11, 2017 11:30 am

I'm pretty sure they are alnico 5.

by (**teeder**) » Wed Jan 11, 2017 2:33 pm

That was my guess.

So .... replacing them with alnico II's would probably sweeten the high end a little?

by (**jps**) » Wed Jan 11, 2017 2:45 pm

Not sure, but I do know they would be III less then before. :mrgreen:

by (**teeder**) » Wed Jan 11, 2017 3:53 pm

Maybe I should get some that go to 11?

:lol:

by (**teeder**) » Mon Jan 16, 2017 2:43 pm

It looks like I'm going to design and build my own bridge pu.

by (**jps**) » Mon Jan 16, 2017 5:07 pm

That could be fun!

by (**teeder**) » Tue Jan 17, 2017 10:16 am

I'm pretty excited about it. I have a 3-d printer here at work that I'll make the bobbin with. My brother has a winder. Just have to finish taking measurements and draw everything up.

If it goes OK, I'll make a couple and send you one to give it a work-out before I go into production! :lol:

by (**jps**) » Tue Jan 17, 2017 10:23 am

Send me a bass along with the pickup as I'm not sure I want to pull the HS pickup out of the 4001. :mrgreen:

Unless someone wants to buy that pickup. :wink:

by (**teeder**) » Tue Jan 17, 2017 11:03 am

Sounds like a good excuse for a road trip to Cleveland!

RE-HS PU's

RE-HS PU's

Re: RE-HS PU's

Re: RE-HS PU's

Re: RE-HS PU's

Re: RE-HS PU's

Re: RE-HS PU's

Re: RE-HS PU's

Re: RE-HS PU's

Re: RE-HS PU's

Re: RE-HS PU's

Who is online