Physical difference between toasters?
Posted: Fri Apr 06, 2012 1:19 pm
I don't have any 70's toasters to compare to the modern ones...are there any physical dimension differences ?
The reason I'm asking is I have a '72 4001 pickguard and was going to use it on my '73 project. However, when trying to put a modern toaster through the hole, I find that it is an extremely tight fit top to bottom but doesn't fill the sides of the hole... I'm talking gaps of around an 1/8th of an inch on either side....
the control stems don't fit the existing holes in the p/g either....
The reason I'm asking is I have a '72 4001 pickguard and was going to use it on my '73 project. However, when trying to put a modern toaster through the hole, I find that it is an extremely tight fit top to bottom but doesn't fill the sides of the hole... I'm talking gaps of around an 1/8th of an inch on either side....
the control stems don't fit the existing holes in the p/g either....