Tuner / Machine Head poor fit
Posted: Sat Dec 17, 2016 12:46 am
Hi all,
..... oh Rickenbacker factory you got so close to perfection but..........
I've just got a nearly new 360/12 C63. And noticed some of the tuners don't quite sit flat against the headstock by a couple of plectrums thickness but don't feel loose as most of them have one tight screw - Rossetti say "it's the way they're made and not an issue" !!!
Has anyone else had this issue ? Did you get away with just slackening the string & pinching the screws up or is it a machine head off and reposdotion job? Or as Rossetti suggested I just leave it?
Other than that it's a great guitar and despite the tuner not being screwed down fully so far holding tune well.
Any help very welcome
Thank you all
..... oh Rickenbacker factory you got so close to perfection but..........
I've just got a nearly new 360/12 C63. And noticed some of the tuners don't quite sit flat against the headstock by a couple of plectrums thickness but don't feel loose as most of them have one tight screw - Rossetti say "it's the way they're made and not an issue" !!!
Has anyone else had this issue ? Did you get away with just slackening the string & pinching the screws up or is it a machine head off and reposdotion job? Or as Rossetti suggested I just leave it?
Other than that it's a great guitar and despite the tuner not being screwed down fully so far holding tune well.
Any help very welcome
Thank you all