What size of tiny screwdrivers will I need to take the knobs off? I see that I'll need two, for the tone/volume, and that weird "other" button.
Thanks
Screwdriver for Volume/Tone Knob - Set Screws
Moderator: jingle_jangle
-
- New member
- Posts: 12
- Joined: Fri Nov 14, 2014 12:32 pm
Re: Screwdriver for Volume/Tone Knob - Set Screws
WaitingOnRick wrote:What size of tiny screwdrivers will I need to take the knobs off? I see that I'll need two, for the tone/volume, and that weird "other" button.
Thanks
-
- New member
- Posts: 12
- Joined: Fri Nov 14, 2014 12:32 pm
Re: Screwdriver for Volume/Tone Knob - Set Screws
Thanks.
"Weird button" - On the 620. What does it do again? Master volume or some ****.
"Weird button" - On the 620. What does it do again? Master volume or some ****.
Re: Screwdriver for Volume/Tone Knob - Set Screws
Any small, “precision” set will have what you need. Just use the largest size that works / fits in the screw hole and fits into the screw head slot.
You should read this, esp. the “Volume and Tone Controls” section:
http://www.rickenbacker.com/pdfs/manual.pdf
You should read this, esp. the “Volume and Tone Controls” section:
http://www.rickenbacker.com/pdfs/manual.pdf