the ones i've seen on factory guitars look like
they have machined perfect notches.
What's the best way to 'notch' a new bridge?
Moderator: jingle_jangle
The 'machined ' notches are filed .
I use a specific set of files for this task .They are expensive ...about $14.00 USA each
I use a set of round edge 'Grobet' files .These are made in Switzerland .
There are Japanese files that are similar.
These files cut a round edged slot .
On a 12 string I cut the slots so the TOP of the strings follow the 10" radius .This gives you a smoother picking motion across the strings .
At the nut to facilitate smooth /ease of fingering the string notches are cut so the BOTTOM of the strings follow the radius.
I use a set of dial caliper to layout the spacings .For a one off set up this is extremely accurate .It does take more time than laser cutting or CNC ,but I don't think that the Factory cuts are made any other way than by hand with a file.
All the notches are the same in size .
My way ,you get a slot that fits each sized string .
I use a specific set of files for this task .They are expensive ...about $14.00 USA each
I use a set of round edge 'Grobet' files .These are made in Switzerland .
There are Japanese files that are similar.
These files cut a round edged slot .
On a 12 string I cut the slots so the TOP of the strings follow the 10" radius .This gives you a smoother picking motion across the strings .
At the nut to facilitate smooth /ease of fingering the string notches are cut so the BOTTOM of the strings follow the radius.
I use a set of dial caliper to layout the spacings .For a one off set up this is extremely accurate .It does take more time than laser cutting or CNC ,but I don't think that the Factory cuts are made any other way than by hand with a file.
All the notches are the same in size .
My way ,you get a slot that fits each sized string .
So you too want yours "ALAPWOB"?!?!