Nameplates and Such

[jcreasy]

Do the screw holes line up for a 350 V63 nameplate and a modern one like a 360?

Notice how the "... tail" of the vintage nameplate is longer. Is the screw in the same place off the tuenr? If not, would it be covered if I replaced with a modern nameplate?

Finally, will Rick replace a vintage nameplate with a modern? All assuming it is documented and not to create a Fakenbakcer?

Thanks,

JKC

[jdogric12]

They probably won't, but you might get lucky. Even if not, I'll bet the 2 bottom holes would line up.