Page 2 of 2
Posted: Sat Jan 13, 2007 8:58 pm
by cavernplayer
I recently purchased an Ampeg BA115HP and couldn't be happier!
cp
Posted: Sun Jan 14, 2007 8:48 am
by kidvett
Greg,
Yes this is a programmable driver. I have different settings on paper and set the 3 footswitch with the ones I need to have on hand. It's very good as the ajustements are precise & gives you lots of versatility...You can also go directly in the PA with it...I have recently discovered that the 3 settings I use most often have the overall volume lower to what the bass would give me without the driver...
Marc
Posted: Sun Jan 14, 2007 9:06 am
by s4001
I'll be the voice of dissention.
I had one for a few years and it turned out to be mostly inadequate for live situations and long gigs. I eventually sold it and got a Yorkville combo and the Yorkie flat out outperforms it in terms of tone, clarity, punch, volume and reliability for those five hour gigs.
My 2ยข
Posted: Sun Jan 14, 2007 9:18 am
by loendmaestro
I too have had iffy experiences with the SansAmp.
I too love my Yorkville gear!
Only my opinion though....
Posted: Sun Jan 14, 2007 10:56 am
by kidvett
Oh !! Perhaps I said it wrong....
The SansAmp is between the Ric and either: a Mesa Bass 400+ w/ 2 x 15in cabs or for smaller gigs an Ampeg B200R...The line to the PA is from the amp, not from the driver. I havent ( and probably never will ) used the SansAmp without an amp !! I guess the way I use it is more as a pre-amp...
Scott,
Did you use it without an amp & directly into the PA ?? Or before the amp like I do ??