Page 2 of 2
Re: HB1 in bridge position of a 4003
Posted: Sat Jul 19, 2014 2:44 pm
by loverickbass
So I'm finally around to putting this HB1 in my 4003. I'm going to leave the higain in the bridge position. With that being sad, can someone tell me which wires on the HB1 should go to ground and which ones should go to the toggle etc?
Cole
Re: HB1 in bridge position of a 4003
Posted: Sat Jul 19, 2014 4:44 pm
by cjj
loverickbass wrote:So I'm finally around to putting this HB1 in my 4003. I'm going to leave the higain in the bridge position. With that being sad, can someone tell me which wires on the HB1 should go to ground and which ones should go to the toggle etc?
Cole
Oh, it's not really so sad...
The "official" wiring diagram can be found here:
http://www.rickenbacker.com/pdfs/19521-HB1%20Wiring.pdf
Which shows the blue/shield wire goes to ground and red goes to the switch...
Re: HB1 in bridge position of a 4003
Posted: Sat Jul 19, 2014 8:58 pm
by loverickbass
D'OH! LoL, ok thanks for that info brotha. That will bring the higain and the HB1 in phase with each other correct?
Re: HB1 in bridge position of a 4003
Posted: Sat Jul 19, 2014 9:30 pm
by cjj
I've never checked it myself, but others have said that the HB-1 is the opposite phase from the hi-gains. If that's the case, you would have to wire it up backwards to have it in phase...
Re: HB1 in bridge position of a 4003
Posted: Sat Jul 19, 2014 9:38 pm
by loverickbass
So blue goes to switch and red goes to ground.
Cole
Re: HB1 in bridge position of a 4003
Posted: Sun Jul 20, 2014 1:28 am
by cjj
Yes. It might be good to move the shield to the red as well, just to keep things "right" as far as shielding goes...
Re: HB1 in bridge position of a 4003
Posted: Sun Jul 20, 2014 2:40 pm
by loverickbass
OK, looks like I've got an older HB1, it's got red,green,white,black and shield.
Re: HB1 in bridge position of a 4003
Posted: Sat Aug 30, 2014 11:57 am
by kennyhowes
loverickbass wrote:I was going to put HB's in both positions.
I'm thinking about doing this to one of my basses as well. Variety.
Re: HB1 in bridge position of a 4003
Posted: Sat Aug 30, 2014 1:18 pm
by loverickbass
Do it. You won't regret it. Dane made me a new wiring harness for mine. It took a whole lot of the mud away for the HB1.
Re: HB1 in bridge position of a 4003
Posted: Sat Aug 30, 2014 9:59 pm
by VRICKY63
I've got HB1s with Dane's 500k push/pull pots. I love having all the tone options but I usually have the neck HB in humbucking mode and the bridge HB in single coil. Very chesty thump.