Rickresource Rickenbacker Forum

Thanks 3. Nice to see you posting.

admin wrote:Thanks 3. Nice to see you posting.

Only because YOU make it possible, number 1.

The template for the 480XC neck and fretboard is the standard 620.

Thanks Ben. That is very good to hear. I appreciate your comment and please keep the new stuff coming!

sir_andrew_of_left_coast wrote:

admin wrote:Thanks 3. Nice to see you posting.

Only because YOU make it possible, number 1.

am I in The Prisoner????

sir_andrew_of_left_coast wrote:If there is anything "specific" you wanted to know... ask away!

Thanks, that was interesting to read! I had no clue the XC version has a push/pull knob! Thanks

RIC_FACTORY wrote:The template for the 480XC neck and fretboard is the standard 620.

Given that the 650C fingerboard was ok but a tad to wide for my tiny hands to feel completely comfy, at least the 480XC should be familiar to play then!

electrofaro wrote:

RIC_FACTORY wrote:The template for the 480XC neck and fretboard is the standard 620.

Given that the 650C fingerboard was ok but a tad to wide for my tiny hands to feel completely comfy, at least the 480XC should be familiar to play then!

I was happy to see this too.

jdogric12 wrote:

sir_andrew_of_left_coast wrote:

admin wrote:Thanks 3. Nice to see you posting.

Only because YOU make it possible, number 1.

am I in The Prisoner????

If you're number 47, you could say to me
"You're the cutest jailbird I ever did see."

Given that the 650C fingerboard was ok but a tad to wide for my tiny hands to feel completely comfy, at least the 480XC should be familiar to play then!

Fun fact: Initially, the plan was to go with the 650/660 (1 3/4") nut width and that is how the two prototypes we put up on social media back in January were made. Ultimately, we decided the 620/350 width would appeal to more people.

RIC_FACTORY wrote:

Given that the 650C fingerboard was ok but a tad to wide for my tiny hands to feel completely comfy, at least the 480XC should be familiar to play then!

Fun fact: Initially, the plan was to go with the 650/660 (1 3/4") nut width and that is how the two prototypes we put up on social media back in January were made. Ultimately, we decided the 620/350 width would appeal to more people.

Interesting fact Ben! As I'm not active on social media I missed those pictures

I actually had a shredder colleague of mine tell me today that it's not hand size but bad positioning of hands that make people "dislike" certain necks (as we all know shredders are always right )