Page 5 of 5
Posted: Tue May 02, 2006 7:18 pm
by dean712
Ted, thanks for taking the measurements. It's a lot of data points, each requiring a measurement, recording, and data entry.
We're looking forward to perusing the results!
Posted: Tue May 02, 2006 8:14 pm
by bobcat
When I get home from college, I'll use my dad's calipers to measure my 4003 neck.
Posted: Wed May 03, 2006 10:30 am
by johnallg
Ted, if you have the measurements typed into a document of any kind, you can email it to me and I will add it to the database. Or photocopy it and mail it to me and I will do the same. If that helps, let me know which will work and we'll go from there.
[edit] Forgot to add - NICE NECK WORK!! What's it go on?
Posted: Wed May 03, 2006 11:46 am
by rickfan60
That is my final test board for a 4005 project I am working on. It will go on one of my '75s because it is not quite as perfect as I would like it to be for a '67 4005.
Posted: Wed May 03, 2006 11:52 am
by beatlefan
Lookin' good, Ted! Can't wait to see the finished product!!
Posted: Wed Jun 28, 2006 5:44 pm
by johnallg
Any final tabulation of the measurements taken at the Midwest Confluence? Found this old thread looking for other info and wondered.....
Posted: Wed Jun 28, 2006 5:49 pm
by rickfan60
There is a pile of data to add to it. I suppose I should just sit down and do it....
Posted: Wed Jun 28, 2006 6:04 pm
by johnallg
Email it to me and I will get it added to the spreadsheet - I have the time....
Posted: Tue Jul 25, 2006 6:58 am
by ali_b
oops, late to the party again!
1997 v63FG
thickness
fret1 22.0mm
fret7 21.9mm
fret12 22.0mm
fret16 22.8mm
width
nut 43.0mm
fret12 54.6mm