Page 1 of 1
Missing bridge cover screws
Posted: Tue Jul 12, 2005 9:56 am
by teddy_boy
Hi!
Dang, I seem to have lost the screws to the bridge cover of my 620 after I removed the cover. I reckon the screws have dropped out of the case at some point.
Is there any way of getting replacement screws? I was thinking of putting the cover back on again. I'm so angry at myself for not being careful!
Best,
Tom
Posted: Tue Jul 12, 2005 10:29 am
by tony_carey
Thomas, check out this site (Mike Parks)
http://www.the-music-connection.com/ricpart.htm
You'll see that they are .30c each.
I always screw the screws back in to the bridge screw holes, but I noticed the other day that two of my Rics don't have the screws in, so I obviously forgot in the heat of the moment!
Posted: Tue Jul 12, 2005 2:37 pm
by doctorwho
Thomas, I see by your profile that you are in Finland. I don't think Mike Parks can ship out of the USA, so you'll need to find out who is the closest RIC dealer to you.
Posted: Wed Jul 13, 2005 1:25 am
by teddy_boy
Ok,
Thanks guys! I'll have to see what I can do. I wish I had screwed them back in too...
Tom
Posted: Wed Jul 13, 2005 6:15 am
by admin
Teddy Boy: I will be getting some items from Mike in the near future. In the meantime, I can send you out a couple of used screws to do the job if you send me your mailing address off-line through my
[email protected].
Posted: Wed Jul 13, 2005 11:05 am
by tony_carey
Peter, that kind of help typifies this forum...
Welcome to this most wonderful forum Thomas.