Page 1 of 1
4001CS Neck Adjustment
Posted: Wed Nov 09, 2005 1:42 am
by doubleneck
I'm sure it's been discussed before but should the 4001cs truss rod adjustment be performed like an older 4001 or a 4003? The main issue is if the neck should be pulled back of forward before turning the truss rod nuts. Or is just turning them alone the proper procedure.
Posted: Wed Nov 09, 2005 2:26 am
by cheyenne
I would think that the CS would have the newer design.
Posted: Wed Nov 09, 2005 4:15 am
by jwr2
the 4001CS has a 4003 neck and truss rods ... as does the v63 ...
Posted: Wed Nov 09, 2005 4:27 am
by ken_swearingen
The CS, has the newer design.
Posted: Wed Nov 09, 2005 1:35 pm
by doubleneck
Thanks for the response guys. The reason I asked is because there is a VERY small crack in the finish where 4001's fingerboards usually separate. It seems to only be a finish crack and it's only on the low E side of the neck.