Page 1 of 1
Oven knob question
Posted: Fri Feb 03, 2006 9:03 pm
by sloop_john_b
I bought a set of new ones from Mike Parks, yet none of the wrenches I have seem to be able to tighten them. What size allen wrench do I need to tighten them up?
Posted: Sat Feb 04, 2006 7:34 pm
by ratso
Hey John, I unfortunately don't know the answer to your question. Someone here will surely be able to. Leftybass will know for sure. Can you do me a favor? Tell me what the underside of the knob reads please. I'm assuming Rogan Bros. Skokie Ill. Thanks
Posted: Sun Feb 05, 2006 3:10 pm
by sloop_john_b
Thanks Ron - the underside of the knobs indeed say what you assumed they would.
Posted: Sun Feb 05, 2006 10:04 pm
by ratso
Thanks John
Posted: Mon Feb 06, 2006 4:26 am
by leftybass
LOL, I have the wrench but I don't know what size it is!!! FWIW I think it's the same one that adjusts bridge height, but I could be wrong...
Posted: Mon Feb 06, 2006 4:48 am
by jingle_jangle
This is an American wrench, so any metrics will not fit.
I believe it is 3/64".
The bridge height wrench is bigger.