Vintage knob question
Posted: Thu Mar 16, 2006 8:47 am
I just got some vintage knobs from Pickguardian for my 4003. Did anyone else run into a problem where they didn't turn smoothly after you installed them?
They look great, but it's almost like they're to deep. There's a distinct difference between the vintage knobs and factory knobs as far as turning smoothness goes. I'm wondering if I should go out and buy 4 washers for the bottom to create some space.
Anyone else have this happen them?
They look great, but it's almost like they're to deep. There's a distinct difference between the vintage knobs and factory knobs as far as turning smoothness goes. I'm wondering if I should go out and buy 4 washers for the bottom to create some space.
Anyone else have this happen them?
Some knobs have "skirts" that will bottom out on the guard if set too low.