Page 1 of 1
Sealing a dent...
Posted: Wed Oct 11, 2006 9:17 am
by biglittledog
Well I just accidentally (pun intended) put a dent in my fairly new 4003MG. A small round area about 1/2 inch across. Can I use something to seal it and keep dirt and sweat out of the cracked finish? Polyurethane? I mainly don't want the dent to get dark colored with age and show up against the maple...
Thanks in advance!
Posted: Wed Oct 11, 2006 9:46 am
by aceonbass
I'm thinking that super glue would be good for this.
Posted: Wed Oct 11, 2006 10:02 am
by rickfan60
Check with Paul W.
Posted: Wed Oct 11, 2006 10:36 am
by thinneckrick
Best way to do that is drip some clear coat into the dent
Posted: Wed Oct 11, 2006 10:45 am
by jwr2
possibly clear finger nail polish
Posted: Wed Oct 11, 2006 11:12 am
by doctorwho
I suggest cross-posting this in The Vibrola section where the luthiers-in-house will see it for sure.
Posted: Wed Oct 11, 2006 2:39 pm
by ram
I had a couple of those on my '74 4001MG and the clear finger nail polish worked well.
Posted: Thu Oct 12, 2006 5:18 pm
by biglittledog
Thanks for all the ideas!