Rickresource Rickenbacker Forum

Posted: **Tue Oct 24, 2006 4:07 am**

Just out of curiosity, how hard would it be to have checkered binding put on a 4003? I'm thinking of ordering one in AFG and the binding would make it look complete IMO.

Posted: **Tue Oct 24, 2006 4:27 am**

The age old question. It is not currently available on any new basses from RIC. Ted has proven that it can be retrofitted, but requiring a refinish.

Posted: **Tue Oct 24, 2006 5:10 am**

The old binding would have to be removed and an step of .060" cut beyond the existing route. While this could be done with minimal damage to the finish, Wes is correct in that a partial re-finish would be required afterwards.

Posted: **Tue Oct 24, 2006 6:46 am**

It's actually available on the 4004LK, but that's about the same as saying it's not available.

I've had checkered binding put on all my basses, except for my 4000. I usually get basses in unplayable condition and have it done then as part of the process of bringing them back from the dead.

Posted: **Tue Oct 24, 2006 8:18 am**

Greatful dead!

Posted: **Tue Oct 24, 2006 9:22 am**

I was questioning the checked binding thing a while back. I kinda like to see it on a 360.

Posted: **Tue Oct 24, 2006 9:36 am**

Ron, check out "the Vibrola" part of the Forum; "Dale Fortune 4003 to 4001" thread.

Posted: **Tue Oct 24, 2006 11:59 pm**

checked binding on a 4003...

Posted: **Wed Oct 25, 2006 12:54 am**

"... how hard would it be to have checkered binding put on a 4003?"

25 CPJP* or 23?

___________________________________________
* Checks Per Jack Plate length

Posted: **Wed Oct 25, 2006 4:33 am**

Jared, I did say currently. I love the look of those shadows!

Rickresource Rickenbacker Forum

Checkered binding?

Checkered binding?