Page 1 of 1
K&K Installation for the SoCal Confluence
Posted: Sat Aug 18, 2007 2:42 pm
by charlyg
I'm not sure if I can pull this one off. It is K & K's Western Mini. The main question I have is, how difficult is it to pull the end pin on an acoustic?I'm talking about my Takamine GS330S. They recommend having a pro do it if it is glued, but mine looks like the standard tapered snug fit end pin. It is an interesting procedure none the less. You are super gluing three "mic" pads under the soundboard just below the saddle. and drilling the endpin hole to 1/2 inch. That's pretty much it, but I won't attempt if it's a b...... to get the pin out. I'll just take it to Truetone. But I though it may be interesting for those looking for an inexpensive but good sounding pup for their acoustic.
Posted: Mon Aug 20, 2007 3:50 pm
by rickenbrother
The guitar version of some string winders have a notch in the side to make pulling those pins out a bit easier.
Posted: Mon Aug 20, 2007 4:30 pm
by charlyg
Well, I'll bring it, and if we feel froggy, we'll give it a whirl.
Posted: Mon Aug 20, 2007 4:31 pm
by charlyg
Wait a minute, froggys and whirl?
What's red and green and goes a hundred miles an hour?
or something like that
Posted: Mon Aug 20, 2007 4:32 pm
by rickenbrother
Well, we said we'd have clinic sessions. That could be one project.
Another might be the setup of my 4003 Turquiose.
Posted: Mon Aug 20, 2007 4:35 pm
by charlyg
Yeah, I have the VVTT 4004 mod and the Hipshot D-tuner if I can find the screws. The ones they sent with the product are too short. I got a couple from Dane but they seem to have grown legs and...............
Posted: Mon Aug 20, 2007 4:42 pm
by rickenbrother
Maybe we should bring this to the Confluence section of the forum?
Posted: Mon Aug 20, 2007 4:45 pm
by charlyg
Hmmm....