Page 1 of 1
Another RIO Question
Posted: Fri Apr 11, 2008 12:52 pm
by teeder
Will there be a "repair" table or workshop?
Both of my older basses need some TR tweaking / set-up work, and I'm too chicken to practice on these!
Re: Another RIO Question
Posted: Fri Apr 11, 2008 5:30 pm
by johnallg
teeder wrote:Will there be a "repair" table or workshop?
Both of my older basses need some TR tweaking / set-up work, and I'm too chicken to practice on these!
You notice I didn't offer to do that while I was visiting Kev?
I would be interested in watching them being set up.
Re: Another RIO Question
Posted: Fri Apr 11, 2008 6:18 pm
by incubus2432
I'm sure there will be plenty of people around that'll pitch in and give you a hand.
Re: Another RIO Question
Posted: Fri Apr 11, 2008 6:19 pm
by windchimp
Just make sure there's a 220 outlet handy for the air compressor and the arc welder
Re: Another RIO Question
Posted: Fri Apr 11, 2008 6:38 pm
by jps
Jared is bringing his TIG welder so we got that covered!
I have a smaller room across the hall that could be used for tweakers. The original intent was to put the amps for jamming in there but it can double for a workshop.
Re: Another RIO Question
Posted: Fri Apr 11, 2008 8:38 pm
by incubus2432
jps wrote:I have a smaller room across the hall that could be used for tweakers.
Tweakers?
Re: Another RIO Question
Posted: Fri Apr 11, 2008 8:48 pm
by jps
Not that kind of tweakers!
Re: Another RIO Question
Posted: Mon Apr 14, 2008 9:03 am
by teeder
Thanks, guys!