Page 1 of 1
325V59 Question
Posted: Wed Jul 16, 2008 4:51 pm
by 1OUfan
Can anyone tell me what the fingerboard radius is on the 325V59?
Thanks---
Bob
Re: 325V59 Question
Posted: Wed Jul 16, 2008 4:59 pm
by admin
Bob: I believe the 325V59 had a 10 inch crown radius. But now you have me thinking as the 325C58, for example, has a 7.25" crown radius.
Re: 325V59 Question
Posted: Wed Jul 16, 2008 5:57 pm
by Scastles
Think you are correct, Peter, about the 10 inch radius on the 325 V.
Re: 325V59 Question
Posted: Wed Jul 16, 2008 6:23 pm
by beatlefreak
According to RIC's spec sheet on the model, the 325V59 has a 12" crown radius.
Re: 325V59 Question
Posted: Wed Jul 16, 2008 10:18 pm
by admin
Kris: Is this the same for the 325V63?
Re: 325V59 Question
Posted: Thu Jul 17, 2008 8:40 am
by wj350
FWIW, I show 10" crowns on the v59 and v63. There's apparently some question about whether or not V81 (Lennon's) had a 12" or 10" radius, though the C58 is made with a 7.25" radius.
Bill
Re: 325V59 Question
Posted: Thu Jul 17, 2008 9:13 am
by admin
Bill: I felt the 10" radius was right. Time for more research.