Page 1 of 1
What size nut driver?
Posted: Fri Oct 03, 2008 10:26 pm
by congerz83
What size nut driver do I need to purchase to adjust my truss rods? My neck is too straight. Should I adjust in full turns? Half turns? Quarter turns?
Re: What size nut driver?
Posted: Fri Oct 03, 2008 10:56 pm
by blueflamerick
1/4"
Here's a link to the tool RIC sells:
http://www.rickenbacker.com/cart.asp?vi ... ccessories
Adjust in quarter turns, wait a day or two for the neck to settle in, then repeat as necessary.
Re: What size nut driver?
Posted: Fri Oct 03, 2008 11:44 pm
by beatlefreak
Rick, go to any site that sells tools online, and order an Xcelite L8 nutdriver. This is the same driver RIC sells, but you can get them a lot cheaper.
Re: What size nut driver?
Posted: Sat Oct 04, 2008 8:31 am
by congerz83
Do I leave the strings tight while I adjust? Do I losen, adjust and tune to pitch? Or do I loosen adjust, wait two days and tune to pitch?
Re: What size nut driver?
Posted: Sat Oct 04, 2008 10:25 am
by jps
Didn't you learn
anything at MARF II?
Re: What size nut driver?
Posted: Sat Oct 04, 2008 10:26 am
by jps
Re: What size nut driver?
Posted: Sat Oct 04, 2008 11:16 am
by windchimp
Will you also demontrate your nut filing skills?
Re: What size nut driver?
Posted: Sat Oct 04, 2008 11:42 am
by jps
Been there, done that!
Dr.Garner will do the operation at MARF.
Re: What size nut driver?
Posted: Sat Oct 04, 2008 12:01 pm
by congerz83
Jeff I would welcome a refreser!
Re: What size nut driver?
Posted: Sat Oct 04, 2008 3:56 pm
by jps
congerz83 wrote:Jeff I would welcome a refreser!
Soitenly!
Re: What size nut driver?
Posted: Sat Oct 04, 2008 7:03 pm
by ozover50
What size nut driver?
About 6'4" and 340lbs.......... had a run in with one yesterday! No damage done, just a bit of road rage on his behalf!