Page 1 of 2

Guitar amp stand.

Posted: Wed May 06, 2009 6:57 pm
by fireglo67
I'm looking for any recommendations for the best guitar amp stand for my Vox AC30 CC2.
Up until now we've only played larger venues, so the amp was fine on the floor or on a table at the back of the stage, but now we're looking to play some smaller pubs and clubs, so I'm going to need to tilt the amp, or the poor folks in the audience at the front are going to loose their ear drums! :lol:

Any suggestions/thoughts/experiences appreciated.

Ta.

Rob.

Re: Guitar amp stand.

Posted: Wed May 06, 2009 7:16 pm
by paologregorio
I like either the Vox chrome stand, or else an Anvil amp case! Either one is quite the business! :D

I have one of those top of the line flight cases, which are heavier though, so if you get an amp case, I'd sugest getting something a little lighter, namely one of the hard, rolling cases that are lighter and thinner, yet still solid enough to perch your CC2 atop. Unless you fancy doing a hefty weight room clean and jerk maneuver each time you pick the amp up in its case to put in your car or place on stage.

The stand, on the other hand, fits nicely over the top of the amp for carrying and transit, is much lighter, and completely cool looking! :D

Re: Guitar amp stand.

Posted: Wed May 06, 2009 7:19 pm
by jingle_jangle
NCM makes a wheeled tilt trolley for the AC30 that's really the nutz...
AC30trol_add.gif
AC30trol_add.gif (11.25 KiB) Viewed 1019 times

Re: Guitar amp stand.

Posted: Wed May 06, 2009 7:24 pm
by ozover50
Hi Rob.

I use one of these for my Hot Rod Deville:

http://www.quiklok.com/catalog/?p=produ ... ame=BS-317

I had to have it modified a bit so that the rear support didn't push the rear panel of the amp in but that was relatively minor.

Very sturdy, very steady and very reasonably priced. Folds up flat, too!! :D

Re: Guitar amp stand.

Posted: Wed May 06, 2009 7:25 pm
by fireglo67
jingle_jangle wrote:NCM makes a wheeled tilt trolley for the AC30 that's really the nutz...
AC30trol_add.gif

Wow, not seen those before.
A tad pricey at $370, but it looks perfect for the job.
I'm off to check the 'bay first to see if I can get one second hand.
Thanks guys.

Re: Guitar amp stand.

Posted: Wed May 06, 2009 7:27 pm
by fireglo67
ozover50 wrote:Hi Rob.

I use one of these for my Hot Rod Deville:

http://www.quiklok.com/catalog/?p=produ ... ame=BS-317

I had to have it modified a bit so that the rear support didn't push the rear panel of the amp in but that was relatively minor.

Very sturdy, very steady and very reasonably priced. Folds up flat, too!! :D
Thanks Howard, I've seen the quick lok ones advertised here, but they're really cheap and I was a bit worried they'd end up being false economy, but if they do the job well, for the price they look the business.

Cheers.

Re: Guitar amp stand.

Posted: Wed May 06, 2009 7:32 pm
by ozover50
No worries, Rob.... your call.

I'd be crapping myself at $370 for a stand!! :shock:

$65 for the Quiklok works for me! :lol:

Re: Guitar amp stand.

Posted: Wed May 06, 2009 7:36 pm
by fireglo67
ozover50 wrote:No worries, Rob.... your call.

I'd be crapping myself at $370 for a stand!! :shock:

$65 for the Quiklok works for me! :lol:
Aye it's a lot of dough, but the wheels on it would make moving the beast around so much easier, I'm not getting any younger and we don't have roadies!
What I really need is the quik lok stand with strong wheels on it! :lol:

Re: Guitar amp stand.

Posted: Wed May 06, 2009 7:36 pm
by jingle_jangle
Mateybob wrote:
jingle_jangle wrote:NCM makes a wheeled tilt trolley for the AC30 that's really the nutz...
AC30trol_add.gif

Wow, not seen those before.
A tad pricey at $370, but it looks perfect for the job.
I'm off to check the 'bay first to see if I can get one second hand.
Thanks guys.
I've got one, Rob, and the quality is better than originals were--the welds are gorgeous and plating nearly flawless.

Re: Guitar amp stand.

Posted: Wed May 06, 2009 7:40 pm
by fireglo67
jingle_jangle wrote:
Mateybob wrote:
jingle_jangle wrote:NCM makes a wheeled tilt trolley for the AC30 that's really the nutz...
AC30trol_add.gif

Wow, not seen those before.
A tad pricey at $370, but it looks perfect for the job.
I'm off to check the 'bay first to see if I can get one second hand.
Thanks guys.
I've got one, Rob, and the quality is better than originals were--the welds are gorgeous and plating nearly flawless.
Cheers.

I've just mailed North Coast Music in the states for their international shipping fees.

Ta very much chuck.

Re: Guitar amp stand.

Posted: Sat May 09, 2009 4:50 pm
by jps
I use one of these; $40! Works great, and folds flat for travel or storage.

Re: Guitar amp stand.

Posted: Sat May 09, 2009 5:06 pm
by whojamfan
jps wrote:I use one of these; $40! Works great, and folds flat for travel or storage.
So that's where the one out of my hotel went! I've thought about that before, glad to hear someone getting some good use out of one.

Paul, don't those NCM swivels have to be screwed in to your amp? I have the regular one, and it works great.

Rob, just turn up louder! :D

Re: Guitar amp stand.

Posted: Sat May 09, 2009 5:08 pm
by windchimp
jps wrote:I use one of these; $40! Works great, and folds flat for travel or storage.

A "souvenir" from RIO!!!!? :twisted:

Re: Guitar amp stand.

Posted: Sat May 09, 2009 5:09 pm
by gibsonlp
ozover50 wrote:Hi Rob.

I use one of these for my Hot Rod Deville:

http://www.quiklok.com/catalog/?p=produ ... ame=BS-317

I had to have it modified a bit so that the rear support didn't push the rear panel of the amp in but that was relatively minor.

Very sturdy, very steady and very reasonably priced. Folds up flat, too!! :D
I have the very same stand for my Princeton chorus amp, this is a great stand imho.

Re: Guitar amp stand.

Posted: Sat May 09, 2009 5:22 pm
by jps
windchimp wrote:
jps wrote:I use one of these; $40! Works great, and folds flat for travel or storage.

A "souvenir" from RIO!!!!? :twisted:
Nah, I actually had to buy it! :evil: :lol: