Page 1 of 1
A pot of my 4003 is broken!
Posted: Mon Dec 14, 2009 5:50 am
by MiroN
I have find on Rickenbacker web site the bass schematic, but...
Where can I buy a 330k pot?
can I replace the value 330K?
I have find 300k by gibson
Re: A pot of my 4003 is broken!
Posted: Mon Dec 14, 2009 9:55 am
by jps
The 300K pot will work just fine.
Re: A pot of my 4003 is broken!
Posted: Mon Dec 14, 2009 10:30 am
by cjj
A 500k will work just fine too. RIC used to use 500k for tone pots, 250k for volume. They went to 330k because it's easier and cheaper to stock just one value. This gives you a hint that the value is not super critical. If you're really concerned though, you can always put a 1Meg ohm resistor across the ends of a 500k pot and you'll get 333k...
Re: A pot of my 4003 is broken!
Posted: Mon Dec 14, 2009 2:11 pm
by MiroN
GREAT!
Thanks a lot.