Page 1 of 1
Push-pull knob?
Posted: Sat Feb 13, 2010 11:48 am
by congerz83
I would like to install one of these in my C64S. will any push pull pot do? Or should i psend over $30 on this kit?
http://cgi.ebay.com/RICKENBACKER-PRE-20 ... 19b9c7e805
Re: Push-pull knob?
Posted: Sat Feb 13, 2010 12:09 pm
by beatlefreak
I was watching this, but the bid is now up to almost $45. Ridiculous. The Rickenbacker Page has these kits for $15.
Re: Push-pull knob?
Posted: Sat Feb 13, 2010 12:36 pm
by congerz83
Kris YOU ARE CORRECT!! I just ordered two from THE RICKENBACKER PAGE!!! I wanted to contact the high bidder to inform him but, he is hidded. Oh well
Re: Push-pull knob?
Posted: Sat Feb 13, 2010 6:13 pm
by beatlefreak
That push-pull kit auction ended at $44.75.
Re: Push-pull knob?
Posted: Sun Feb 14, 2010 11:01 am
by ken_j
The push pull pot is $9.50 at the RIC boutique. The 0.0047 cap should be about a buck at any electronic supply.
http://www.rickenbacker.com/cart.asp?vi ... lectronics
Re: Push-pull knob?
Posted: Mon Feb 15, 2010 12:35 am
by johnallg
Ridiculous price! And I'm not happy he's using my drawing and profiting by it either....
