Page 1 of 1
'10 360/12 FG
Posted: Sun Mar 28, 2010 9:34 am
by jdogric12
So this arrived this last week. Still not sure what I think. I can definitely say it's much nicer than what was rolling off the line 10 years ago. Very nice finish job. Neck is on the chunky side for my taste, but the improved string spacing seems to compensate for that. My only real complaint is that the truss rod nuts are too close to the headstock to get the RIC adjusting tool in there. Suggestions?
PS big thanks to JK for the hookup on this!
Re: '10 360/12 FG
Posted: Sun Mar 28, 2010 1:55 pm
by scotty
Some flame on it too Jason Congrats.I might get a shot of that in July?
Re: '10 360/12 FG
Posted: Sun Mar 28, 2010 2:12 pm
by jps
Jdog, can you post a closeup shot of the cavity showing the problem?
Re: '10 360/12 FG
Posted: Sun Mar 28, 2010 3:32 pm
by godber
jdogric12aolcom wrote:So this arrived this last week. Still not sure what I think. I can definitely say it's much nicer than what was rolling off the line 10 years ago. Very nice finish job. Neck is on the chunky side for my taste, but the improved string spacing seems to compensate for that. My only real complaint is that the truss rod nuts are too close to the headstock to get the RIC adjusting tool in there. Suggestions?
PS big thanks to JK for the hookup on this!
Have you tried grinding the tool down Jason?
viewtopic.php?f=14&t=391537&p=577356&hi ... te#p577356
Re: '10 360/12 FG
Posted: Mon Mar 29, 2010 10:38 am
by Trav
Looks beautiful, enjoy!
Re: '10 360/12 FG
Posted: Mon Mar 29, 2010 11:02 am
by whojamfan
supposedly a Taylor truss rod tool will work great on Ricks. I ordered a couple, but can't for the life of me remember where I put them-DUH
Re: '10 360/12 FG
Posted: Mon Mar 29, 2010 11:08 am
by whojamfan
Good looking guitar there Jason, hope you get the rod sorted.
Re: '10 360/12 FG
Posted: Tue Jun 22, 2010 10:03 am
by jdogric12
Update - since the weather changed it's nice and straight, I didn't have to do anything! (For sale by the way)