Page 1 of 1
RWRP convert question
Posted: Sat Nov 06, 2010 2:57 pm
by coolhandjjl
I have a 4003 with stock pups, just did the RWRP mod to the bridge pup. Soldering easy. I have a magnet question. I flipped it over top to bottom, but the holes for the winding wire didn't line up anymore, so I then rotated it a 180. This okay?
Re: RWRP convert question
Posted: Sat Nov 06, 2010 11:01 pm
by cassius987
The polarity is based on the long face. So if that has been flipped over... all's fine.
I believe there's only one way to do this mod because of the way the holes in the magnet are lined up so if you did it, you likely did it right.
Re: RWRP convert question
Posted: Sun Nov 07, 2010 10:03 am
by coolhandjjl
Thanks Joshua. All is then well. Really does cancel all the noise!