Put in my Humbucker

[coolhandjjl]

I finally got to putting the Ric Humbucker in my 4003's bridge position. The original Hi-Gain had solder connections to the back of one the pots where all kinds of wires were soldered, and one went to the toggle. For the Humbucker, I soldered the shield wire to the back of the pot, and the red wire to the toggle switch. Not sure if polarity is correct, or if it matters here. I was running my Hi-Gain as a RWRP, so the yuccky noise is now back.

Anyway, the Humbucker sounds really cool.