Rickresource Rickenbacker Forum

Hi,
It is very hard to get the original 325c58 toasters, so i got a lon pole toaster, but do not want to route my guitar!
Which is the best way to cut the poles, which tool is best to use(dremel?).
are they of a very hard material or tend to split!
Thanks for any help!

Peter

I think it would be a whole lot easier to get the right length magnets.

http://www.magnetsource.com/Solutions_P ... lnico.html

+1, Apart from the fact they are harder than the dremel tool, any heat generated cutting will kill the magnet.

Stupid question - apart from very carefully, how do you get them out?

godber wrote:Stupid question - apart from very carefully, how do you get them out?

Not so stupid. Take pliars and wiggle them out.

Yup. And if you can't find pliars, pliers will work, too!

jingle_jangle wrote:Yup. And if you can't find pliars, pliers will work, too!

Some of the new tools are pliars - the aren't really pliers. Okay, I was typing fast and I'm used to auo-correct on the phone.

johnallg wrote:

jingle_jangle wrote:Yup. And if you can't find pliars, pliers will work, too!

Some of the new tools are pliars - the aren't really pliers. Okay, I was typing fast and I'm used to auo-correct on the phone.

Good advice from the pliars of our community.

Hello folks,

Maybe i can get an original 325C58 Pickup and don´t have to modify the 7.5k Toaster. If so, i have this Toaster for sale !!

Peter