Screwdriver for Volume/Tone Knob - Set Screws

Setup, repair and restoration of Rickenbacker Instruments

Moderator: jingle_jangle

Post Reply
WaitingOnRick
New member
Posts: 12
Joined: Fri Nov 14, 2014 12:32 pm

Screwdriver for Volume/Tone Knob - Set Screws

Post by WaitingOnRick »

What size of tiny screwdrivers will I need to take the knobs off? I see that I'll need two, for the tone/volume, and that weird "other" button. :)

Thanks
User avatar
jps
RRF Consultant
Posts: 37132
Joined: Wed Feb 12, 2003 6:00 am

Re: Screwdriver for Volume/Tone Knob - Set Screws

Post by jps »

WaitingOnRick wrote:What size of tiny screwdrivers will I need to take the knobs off? I see that I'll need two, for the tone/volume, and that weird "other" button. :)

Thanks
:?
WaitingOnRick
New member
Posts: 12
Joined: Fri Nov 14, 2014 12:32 pm

Re: Screwdriver for Volume/Tone Knob - Set Screws

Post by WaitingOnRick »

Thanks.

"Weird button" - On the 620. What does it do again? Master volume or some ****. :)
maxwell
Member
Posts: 361
Joined: Sun Dec 04, 2011 4:14 pm

Re: Screwdriver for Volume/Tone Knob - Set Screws

Post by maxwell »

Any small, “precision” set will have what you need. Just use the largest size that works / fits in the screw hole and fits into the screw head slot.

You should read this, esp. the “Volume and Tone Controls” section:

http://www.rickenbacker.com/pdfs/manual.pdf
Post Reply

Return to “"Vibrola" Rickenbacker Technical Forum: By Paul Wilczynski”