Page 1 of 1
Screwdriver for Volume/Tone Knob - Set Screws
Posted: Sat Oct 31, 2020 4:07 pm
by WaitingOnRick
What size of tiny screwdrivers will I need to take the knobs off? I see that I'll need two, for the tone/volume, and that weird "other" button.
Thanks
Re: Screwdriver for Volume/Tone Knob - Set Screws
Posted: Sat Oct 31, 2020 5:45 pm
by jps
WaitingOnRick wrote:What size of tiny screwdrivers will I need to take the knobs off? I see that I'll need two, for the tone/volume, and that weird "other" button.
Thanks
Re: Screwdriver for Volume/Tone Knob - Set Screws
Posted: Sat Oct 31, 2020 8:03 pm
by maxwell
Re: Screwdriver for Volume/Tone Knob - Set Screws
Posted: Sun Nov 01, 2020 12:25 pm
by WaitingOnRick
Thanks.
"Weird button" - On the 620. What does it do again? Master volume or some ****.
Re: Screwdriver for Volume/Tone Knob - Set Screws
Posted: Mon Nov 02, 2020 9:22 am
by maxwell
Any small, “precision” set will have what you need. Just use the largest size that works / fits in the screw hole and fits into the screw head slot.
You should read this, esp. the “Volume and Tone Controls” section:
http://www.rickenbacker.com/pdfs/manual.pdf