Page 1 of 1
Stereo volume pedal
Posted: Fri May 21, 2021 5:28 pm
by StevieDee
I was wondering if anyone knows of a volume pedal that takes a TRS input from a Ric and splits the signal to two mono outputs. I have a home made Rickosound which is great but I’ve just bought a Helix Stomp and I’d rather use the expression for switching snapshots than volume. If I could get a volume pedal I could dispense with my DIY Rickosound. Cheers!
Re: Stereo volume pedal
Posted: Fri May 21, 2021 6:16 pm
by cjj
The Ernie Ball Stereo Volume/Pan pedal should do what you want.
With a TRS plugged into the "B IN STEREO", the Tip goes through the lower volume pot to the Tip of "B OUT STEREO", plug a mono cable in here.
The Ring signal goes through the "A IN MONO" switch (don't plug anything in here so the switch stays closed), then through the "VOLUME/PAN SWITCH", then through the upper volume pot to the Tip connection on "A MONO OUT". This is where the other mono cable is plugged in.
Re: Stereo volume pedal
Posted: Sat May 22, 2021 4:18 am
by StevieDee
Thanks that looks like it will do the trick!
Re: Stereo volume pedal
Posted: Sun May 23, 2021 8:24 pm
by Korladis
StevieDee wrote:Thanks that looks like it will do the trick!
More like it'll do the tRICK, right? Heh heh, couldn't resist.
Re: Stereo volume pedal
Posted: Mon May 24, 2021 1:56 am
by clasbas
Korladis wrote:StevieDee wrote:Thanks that looks like it will do the trick!
More like it'll do the tRICK, right? Heh heh, couldn't resist.
