Guitar Storage
Moderators: rickenbrother, ajish4
Guitar Storage
I have about 10 Rics and 10 other guitars and I want to case store them in some type of shelving units. I found this on the net http://www.btinternet.com/~aaronsound/musicware/ but I want to keep them in their cases. Does anyone know of a product like this or has anyone made one?
I do not need it to look like furniture as pictured above, I am more concerned with ease of access.
I do not need it to look like furniture as pictured above, I am more concerned with ease of access.
-
shamustwin
- Senior Member
- Posts: 5287
- Joined: Tue Apr 29, 2003 5:00 am
I can't locate the picture I thought I had (it may actually be a Polaroid, not digital shot, so I need to check that). Here is a bad picture of the rack behind the door and a diagram of it:
All the wood, solid "cheapo" quality pine, was used as-is from Home Depot, no cutting was required. The vertical pieces (four in total) were attached to the "shelves" with wood screws, three to each segment, 36 total, and I drilled pilot holes to avoid splitting the wood.
The spacing between "shelves" was set based on the height of a typical guitar case. I used 1x10's for the shelves so that the rack would not only fit behind the door, but also hold eight guitars in their cases (I'm pretty sure that they were 48" long, because if they were 36" long the guitar cases would have extended over the end, and I remember that they did not do that). One could use 1x12s to fit wider cases (like those for acoustics) or more guitars per "shelf", but I'd measure the case widths first to confirm that three would fit.
One other thing I did was to buy some cheap outdoor carpet (again, at Home Depot) and covered the shelves with it (I used tacks, but it could be glued down instead) to protect the cases as I slid them in and out.
For additional stability (and because I live in earthquake country), I put a wood screw through one of the verticals into a stud in the wall it was against.
The only tools needed are a drill, an 1/8" or so drill bit (for the pilot holes), a Phillips head driver bit (to drive the wood screws), a hammer (if tacking carpeting), and a tape measure.
If you have any questions or need additioanl details, please let me know.
All the wood, solid "cheapo" quality pine, was used as-is from Home Depot, no cutting was required. The vertical pieces (four in total) were attached to the "shelves" with wood screws, three to each segment, 36 total, and I drilled pilot holes to avoid splitting the wood.
The spacing between "shelves" was set based on the height of a typical guitar case. I used 1x10's for the shelves so that the rack would not only fit behind the door, but also hold eight guitars in their cases (I'm pretty sure that they were 48" long, because if they were 36" long the guitar cases would have extended over the end, and I remember that they did not do that). One could use 1x12s to fit wider cases (like those for acoustics) or more guitars per "shelf", but I'd measure the case widths first to confirm that three would fit.
One other thing I did was to buy some cheap outdoor carpet (again, at Home Depot) and covered the shelves with it (I used tacks, but it could be glued down instead) to protect the cases as I slid them in and out.
For additional stability (and because I live in earthquake country), I put a wood screw through one of the verticals into a stud in the wall it was against.
The only tools needed are a drill, an 1/8" or so drill bit (for the pilot holes), a Phillips head driver bit (to drive the wood screws), a hammer (if tacking carpeting), and a tape measure.
If you have any questions or need additioanl details, please let me know.
It is better, of course, to know useless things than to know nothing. - Seneca
-
shamustwin
- Senior Member
- Posts: 5287
- Joined: Tue Apr 29, 2003 5:00 am
-
spencer
I've just come up with a plan for my guitars. Right now, I've got five electrics and two acoustics sitting in various parts of the house on these little tripod stands. I like to keep them out - never know what mood will strike. I considered building a slotted rack, like a touring case for five electrics. But being as my stepdad own a guitar store, I thought it would be easier to get a scrap of slatwall and just the hooks. I'd get the angled ones so I could put more together than the hooks that hold them flat out. I'll post some pictures when I get it done.
Of course at the moment the consideration is for five of them. I'm sure that will double in years to come.
Of course at the moment the consideration is for five of them. I'm sure that will double in years to come.
It is always of interest to see different methods of storing guitars. So here is my two cents. I am not a fan keeping guitars on stands or on wall hooks as a method of storage. I have seen some beautiful guitars ruined over the years because of "freak" accidents poor stands. I find that storing the intruments in the cases is the best policy as it serves to protect them and alows for better humidity control as well.
I find that standing them in an upright position on the floor against a wall allows for easy access, while at the same time provides for their safety. Simple brackets keep them aligned very well. While I would be the first to agree that not seeing them all at once may have its limitations, at least I know they are safe.
Nonetheless, I continue to admire the ingenuity of others in their endeavour to store their instruments.
I find that standing them in an upright position on the floor against a wall allows for easy access, while at the same time provides for their safety. Simple brackets keep them aligned very well. While I would be the first to agree that not seeing them all at once may have its limitations, at least I know they are safe.
Nonetheless, I continue to admire the ingenuity of others in their endeavour to store their instruments.
Life, as with music, often requires one to let go of the melody and listen to the rhythm
Please join the Official RickResource Forum Facebook Page https://www.facebook.com/groups/379271585440277
Please join the Official RickResource Forum Facebook Page https://www.facebook.com/groups/379271585440277
The link works for me, but it gives me only this login page:
http://www.beatgearcavern.com/forum/login.php?redirect=viewtopic.php&p=0&start=0
http://www.beatgearcavern.com/forum/login.php?redirect=viewtopic.php&p=0&start=0
It is better, of course, to know useless things than to know nothing. - Seneca

