Page 1 of 1
Trussrod stuff
Posted: Wed Dec 08, 2004 2:59 am
by jaymi
*Crosspost*
I am trading for a 78 azureglo 4001 that is going to need some neck work and I asked for pictures of the rod ends with the TRC off and it appears that the metal piece behind the nuts is wacked. Does anyone have one of these or know where I can get one? I will try to post a pic so you can see...
Posted: Wed Dec 08, 2004 3:05 am
by jaymi
Pic
Posted: Wed Dec 08, 2004 3:07 am
by jaymi
More
Posted: Wed Dec 08, 2004 3:09 am
by jaymi
and
Posted: Wed Dec 08, 2004 3:11 am
by jaymi
Dane Wilder, What do you think????
Posted: Wed Dec 08, 2004 7:10 am
by rhampshire
Check my post in the wanted section.
Posted: Wed Dec 08, 2004 7:27 am
by jaymi
Got it...Will have to see what I can figure out..
Posted: Wed Dec 08, 2004 7:30 am
by rhampshire
If you want one of the original blocks, I have a few I think, but I don't recall what kind of shape they're in. I'll check tonight.
Posted: Wed Dec 08, 2004 7:32 am
by jaymi
That's cool. let me know...
Posted: Wed Dec 22, 2004 6:41 am
by jaymi
This bass should be here before New Years and I will have to give a full explanation..
Posted: Thu Dec 23, 2004 8:01 am
by aceonbass
Jaymi..I just say this thread and your Q. I would say the rods could use removing and re-arcing along with the usual thread chasing. The aluminum block does look a bit wacked but my luthier made me a new one along with some stainless washers and brass adjusting nuts for about $30.00.
Posted: Thu Dec 23, 2004 9:05 am
by jwr2
I find every winter it get's dry in my house and the necks of my basses shrink and I have to tighten the truss rods to counter the shrinkage ... then every summer it gets humid and the wood expands so I have to back off the truss rods ... some basses I can just adjust the bridge to compensate ...