4001CS Neck Adjustment

doubleneck · Post by **doubleneck** » Wed Nov 09, 2005 1:42 am

I'm sure it's been discussed before but should the 4001cs truss rod adjustment be performed like an older 4001 or a 4003? The main issue is if the neck should be pulled back of forward before turning the truss rod nuts. Or is just turning them alone the proper procedure.

cheyenne · Post by **cheyenne** » Wed Nov 09, 2005 2:26 am

I would think that the CS would have the newer design.

jwr2 · Post by **jwr2** » Wed Nov 09, 2005 4:15 am

the 4001CS has a 4003 neck and truss rods ... as does the v63 ...

ken_swearingen · Post by **ken_swearingen** » Wed Nov 09, 2005 4:27 am

The CS, has the newer design.

doubleneck · Post by **doubleneck** » Wed Nov 09, 2005 1:35 pm

Thanks for the response guys. The reason I asked is because there is a VERY small crack in the finish where 4001's fingerboards usually separate. It seems to only be a finish crack and it's only on the low E side of the neck.