Parts question

deep_red · Post by **deep_red** » Wed Nov 09, 2005 5:26 am

Got a question. I have a 05' 4003 and a Nov. 73' 4001, are the tailpeice, bridge and pickups interchageable between the two? i am talking about hole spacings and so on. I was also wondering if anyone knows if there was several different versions of tone/vol knobs that came stock from 73', they look a touch fatter than what I have seen, and they have the silver top on them but no writing, a line and no dot.

kcole4001 · Post by **kcole4001** » Wed Nov 09, 2005 5:40 am

They might be cheap replacement knobs. My 4001 had those when I got it. The proper ones aren't expensive or rare.

rickfan60 · Post by **rickfan60** » Wed Nov 09, 2005 5:50 am

The hole spacing should be the same between 05 and 73. Does your 05 have the two extra screws that prevent pullup?

deep_red · Post by **deep_red** » Wed Nov 09, 2005 6:02 am

not sure the 73' has 5 screws, 3 under the bridge and the 2 more towards the back of the tailpiece, I am pretty much posisitve the 05' has the same 5, just not sure if they were spaced the same

rickfan60 · Post by **rickfan60** » Wed Nov 09, 2005 6:03 am

I think the 5 screw versions all have the same spacing.

ken_swearingen · Post by **ken_swearingen** » Wed Nov 09, 2005 6:55 am

This is true.