Oven knob question

sloop_john_b · Post by **sloop_john_b** » Fri Feb 03, 2006 9:03 pm

I bought a set of new ones from Mike Parks, yet none of the wrenches I have seem to be able to tighten them. What size allen wrench do I need to tighten them up?

ratso · Post by **ratso** » Sat Feb 04, 2006 7:34 pm

Hey John, I unfortunately don't know the answer to your question. Someone here will surely be able to. Leftybass will know for sure. Can you do me a favor? Tell me what the underside of the knob reads please. I'm assuming Rogan Bros. Skokie Ill. Thanks

sloop_john_b · Post by **sloop_john_b** » Sun Feb 05, 2006 3:10 pm

Thanks Ron - the underside of the knobs indeed say what you assumed they would.

ratso · Post by **ratso** » Sun Feb 05, 2006 10:04 pm

Thanks John

leftybass · Post by **leftybass** » Mon Feb 06, 2006 4:26 am

LOL, I have the wrench but I don't know what size it is!!! FWIW I think it's the same one that adjusts bridge height, but I could be wrong...

jingle_jangle · Post by **jingle_jangle** » Mon Feb 06, 2006 4:48 am

This is an American wrench, so any metrics will not fit.

I believe it is 3/64".

The bridge height wrench is bigger.