4003 Trussrod nut sheared off!

simer4001 · Post by **simer4001** » Sun May 28, 2006 5:52 pm

John, good to see you posting again.

geddeeee · Post by **geddeeee** » Mon May 29, 2006 6:55 am

Many thanks! I'll give it a try. The 'E' side rod is about 1/2" inside the end of the neck, so it's a lot of compression.
Not my fault either. It's always been like that!!!

johnhall · Post by **johnhall** » Mon May 29, 2006 6:58 am

I'm still steaming about some things that were said earlier in the year but someone else encouraged me by e-mailing "your input and influence are necessary and helpful to keep the dorks from ruling the roost."

incubus2432 · Post by **incubus2432** » Mon May 29, 2006 7:10 am

I'm glad you are posting here again as well but I have little confidence that the "dorks" mentioned above will not ruin things again. I hope I'm wrong of course.

I also feel your experience and knowledge is a great asset to this Forum.

geddeeee · Post by **geddeeee** » Mon May 29, 2006 7:40 am

I think some people have problems putting their frustrations into words without coming across as brutal or insensitive.
I myself have said a few tough things against RIC, in the midst of my trussrod problems, but hopefully I didn't overstep the mark and they were constructive criticisms, rather than a tirade or tantrum.....

rickenbrother · Post by **rickenbrother** » Mon May 29, 2006 7:51 am

John, I am also glad to see that you've returned. I've learned alot from you these past few years. Your input here is greatly appreciated. I'm sure that's how most of us here feel.

fireglo · Post by **fireglo** » Mon May 29, 2006 1:03 pm

I also love hearing from John and Ben. Thank you for your time and insight. I appreciate it!