Dual mono - Please explain
Moderator: jingle_jangle
Dual mono - Please explain
Sorry, but for the millionth time, can someone explain to me how the dual mono on a v64 works? Thanks gang - J Dizzle
-
jwr2
- beatlefreak
- Senior Member
- Posts: 6160
- Joined: Wed Jun 14, 2006 5:45 am
- Contact:
-
jwr2
- beatlefreak
- Senior Member
- Posts: 6160
- Joined: Wed Jun 14, 2006 5:45 am
- Contact:
Power divides in a parallel circuit. For two amps with equal input impedance, the power would divide in half. This causes a -3dB drop in each amp input. 3dB is the minimal amount of difference that the human ear can discern. You may not hear any difference, but the input to each channel is less. This is basic electronics.
Ka is a wheel.
-
jwr2
I just rewired my 12-string with two mono jacks. I had previously wired-in a toggle so that I could mix the middle pickup in with either the neck pickup (toaster) or bridge pickup (toaster-covered high-gain) or turn it off. I played around with another toaster and with another high-gain in the middle position and didn't feel like either one really added very much to the overall sound. I also noticed that when using the JangleBox that it did great things for the highs, but really weakened the low end, which I didn't like. I bought a Ric-O-Sound box to see about splitting the signal to run one through the JB and one straight to add some bottom but it just didn't do what I wanted either. So, I sent it back, pulled the old jacks and put in two mono jacks. The "normal" jack now runs the neck/bridge combo with the original toggle and fifth knob just like a stock 360 and I run it into the JangleBox and one amp channel or amp. The middle toaster now runs straight to the second jack and to a different channel or a different amp. I have a knob and a pot for volume ordered for it, but at the moment it's just wired right to the jack. In any case, the mid pickup now really adds something to the sound and I can mix-in as much of that nice, toaster bottom end as I want with the bright stuff coming out of the JangleBox. Two cords and two channels is a bit more hassle, but I played a bass set up that way for years without a problem and the sound quality is much fuller and richer.
One other use of dual mono output is when comparing two amps in order to determine the settings on each that gives the "same" sound. I did this with my 370/12v64 and was able to dial in my Crate GX40C+ settings to closely match the output from my 1968 silverface Fender Twin Reverb.
It is better, of course, to know useless things than to know nothing. - Seneca

