Is my 4003 wired incorrectly?? Please help!!

olegunnar32 · Post by **olegunnar32** » Tue May 22, 2007 10:45 am

Please can someone confirm or deny that the following setup of my 4003 Bass is
correct/incorrect. This is my first 4003 and just want to know if this is wired right as it seems a little strange to me being a 4003 amateur. Apologies if this is common knowledge.

Plugged Into Rick o Sound input:

Switch in South position = Only Treble knob/ Bridge Pickup Works.
Switch in Middle position = Only Treble knob/ Bridge Pickup Works.
Switch in North position = Neither Treble nor Bass knobs/pickups work.

Plugged into standard Output:

Switch in South position = Only Treble knob/ Bridge Pickup Works.
Switch in Middle position = Both Bass knob/Neck pickup and Treble knob /Bridge pickup Work.
Switch in North position = Only Bass knob/Neck pickup works.

Does this sound correct to you guys?

geddeeee · Post by **geddeeee** » Tue May 22, 2007 10:50 am

Wired correctly. If you plug into ROS with a mono cable you will only get the bridge p-up working. Try a stereo cable.

stts64 · Post by **stts64** » Tue May 22, 2007 10:57 am

Yap, everything like it was meant to be.

olegunnar32 · Post by **olegunnar32** » Tue May 22, 2007 11:42 am

Cheers for you help guys. I will indeed give the the stereo cable a try. Thanks

bob_the_bass · Post by **bob_the_bass** » Wed May 23, 2007 1:34 am

Ideally for the RoS jack you need a Y-splitter cable, ie a stereo jack at the bass end & two monos at the other) - this allows you to feed the bridge pickup to one amp/desk channel & the neck pickup to a seperate amp/desk channel

jwr2 · Post by **jwr2** » Wed May 23, 2007 2:28 am

you can get a splitter at Radio Shack or Guitar Center ...