String height - What action do you like most?

Setup, repair and restoration of Rickenbacker Instruments

Moderator: jingle_jangle

Post Reply
sashua
Member
Posts: 402
Joined: Wed Jan 18, 2006 9:53 am
Contact:

String height - What action do you like most?

Post by sashua »

I am building a guitar and, by nature of its unique design it will not have adjustable action. I, therefore, need to decide on a decent set string height at ,say, the 2nd and 25th frets.

I'd love to get a consensus on what other guitarists like to use. Personally, I like my action quite low - just barely over the point where string buzz sets in over the first couple of frets. I'm guessing about 1.5mm at the 25th fret, and about 0.8mm at the headstock end.

What do you like?

-Russ
BobKat
Advanced Member
Posts: 1712
Joined: Fri Feb 13, 2004 9:18 am

Re: String height - What action do you like most?

Post by BobKat »

Low, low action.
User avatar
sloop_john_b
Rick-a-holic
Posts: 13843
Joined: Tue Jan 25, 2005 6:00 am

Re: String height - What action do you like most?

Post by sloop_john_b »

As Dr. Arnquist might say, ALAPWOB.
User avatar
scotty
Senior Member
Posts: 7097
Joined: Thu Nov 22, 2007 11:27 am

Re: String height - What action do you like most?

Post by scotty »

As close as a Baw Hair!(Glasgie Slang)
User avatar
paologregorio
Senior Member
Posts: 6376
Joined: Wed Aug 08, 2007 12:56 pm
Contact:

Re: String height - What action do you like most?

Post by paologregorio »

Ditto all the previous answers! :D
User avatar
cheyenne
Veteran RRF member
Posts: 6263
Joined: Fri Feb 16, 2001 11:39 am

Re: String height - What action do you like most?

Post by cheyenne »

I take it down til it buzzes then raise it just a 'smidge.
"Knowledge is Power"
phlemmy

Re: String height - What action do you like most?

Post by phlemmy »

i like mine sounding like a small herd of bumblebees.
User avatar
scott_s
Veteran RRF member
Posts: 612
Joined: Mon Nov 26, 2001 12:59 pm

Re: String height - What action do you like most?

Post by scott_s »

With a capo at the 1st fret to factor out nut height, I like 4/64"-5/64" @ 13th fret, ~0.05" relief. I could set it lower, but I don't like the "plink" I'd get when I dig in. This action lets it ring out pretty nicely, even when I bash it. 8)

- Scott
Post Reply

Return to “"Vibrola" Rickenbacker Technical Forum: By Paul Wilczynski”