Remagnetizing a horse shoe....

[chefothefuture]

Gonna be re-chroming some horsies and they're likely
to loose gauss.
Anyone know how to re magnetize them? Sergio? Paul? Dale?.....

[soundmasterg]

It was posted here in one of the sections once before...you could try a search for it? Probably in the pickup section I'd guess...

I seem to remember the shoes are taken off and hooked up to a powerful magnet such as on a welder or a big speaker perhaps? I forgot...but it is something like that....and then you leave it on there for a day or so.

Greg

[wints]

I saw somewhere here where one member had fitted them to each side of a speaker cone.....

[grazioso]

two big neo magnets will do it. watch you fingers with it!

[rickcrazy]

Atsushi Yoshida, where are you?

[s4001]

Not a horseshoe, but I had Lindy Fralin remagnetize my '68.

[sir_andrew_of_left_coast]

With 'shoes and a hammer in hand, make a trip to the Earth's magnetic North Pole. It's in Canada, somewhere. If you get lost, stop at Peter McCormack's place for a sandwich and directions. Once you get to the Pole, give the 'shoes a good smack with the hammer and you'll be set.

Watch out for the polar bears, though...

[rickcrazy]

Hehehe

[oyoyobeatle]

Too late , sorry about that...

[rickcrazy]

Hey Atsushi! Where have you been?

[weemac]

Gonna be re-chroming some horsies and they're likely
to loose gauss.

You only have to wave a soldering iron, or fart near them and they will lose gauss!
emac.

[ryan.jones]

stick inside big welder coils, short welder leads, few minutes or so?