What size nut driver?

[congerz83]

What size nut driver do I need to purchase to adjust my truss rods? My neck is too straight. Should I adjust in full turns? Half turns? Quarter turns?

[blueflamerick]

1/4"

Here's a link to the tool RIC sells: http://www.rickenbacker.com/cart.asp?vi ... ccessories

Adjust in quarter turns, wait a day or two for the neck to settle in, then repeat as necessary.

[beatlefreak]

Rick, go to any site that sells tools online, and order an Xcelite L8 nutdriver. This is the same driver RIC sells, but you can get them a lot cheaper.

[congerz83]

Do I leave the strings tight while I adjust? Do I losen, adjust and tune to pitch? Or do I loosen adjust, wait two days and tune to pitch?

[jps]

Didn't you learn anything at MARF II?

[jps]

Leave the strings at pitch at all times. I guess we need to do a refresher course at MARF III, eh?

[windchimp]

Leave the strings at pitch at all times. I guess we need to do a refresher course at MARF III, eh?

Will you also demontrate your nut filing skills?

[jps]

Been there, done that!

Dr.Garner will do the operation at MARF.

[congerz83]

Jeff I would welcome a refreser!

[jps]

Jeff I would welcome a refreser!

Soitenly!

[ozover50]

What size nut driver?

About 6'4" and 340lbs.......... had a run in with one yesterday! No damage done, just a bit of road rage on his behalf!