Silencing the Hum...

[k5koy]

Hey everyone, I have a 2004 4003 Ric that produces a noisy hum. It is not a ground issue, it is a shielding issue. I have procured the copper tape for the back of the pickguard, shielded wiring, and the conductive paint for the cavities. As I am new to this process, I am wondering if anyone knows a link or has experience with some good concise instructions, tips, etc. Any help would be greatly appreciated. Thanks...

Koy Carson
West Texas

**Carvin AC175 Thinline Acoustic
**Ibanez EW20ZW Electric/Acoustic
**Arbor AJ145CR Jazz
**Fender FSR Silver Sparkle Bass
**Fender Geddy Lee Signature Bass
**Rickenbacker 4003 Jetglo Bass
**Warwick Corvette 4 Standard Hybrid
**Tradition Fretless Bass
**Takamine Hollow body Bass

Texas Bassist Club #66
Fender Jazz Bass Club #328

"You're Gonna Miss Me" By Carson-Blevins Blues Project
http://soundclick.com/share?songid=7216182

http://www.myspace.com/k5koy

[johnallg]

Koy, forget the paint, use the copper, line all routs with it, leave a little over the top of the body to mate to the copper you back the pickguard with, and solder all joints in the routs. Make sure the copper is tied to ground at one place only. You want a "box" with only holes for the pickups. You will still pick up interference from the pickups but only from a source that is right in front of them - they are still single coil pickups. Done properly it will make a difference.

[s4001]

Thanks!

[cassius987]

Koy, forget the paint, use the copper, line all routs with it, leave a little over the top of the body to mate to the copper you back the pickguard with, and solder all joints in the routs. Make sure the copper is tied to ground at one place only. You want a "box" with only holes for the pickups. You will still pick up interference from the pickups but only from a source that is right in front of them - they are still single coil pickups. Done properly it will make a difference.

1. Where is the best place to connect the one ground point from all of this copper?

2. Should you also line the treble pickup cavity, independently as its own copper box? After all it can't be contiguous with the other box. If so, where does one best ground THIS box?

My 4003s do experience DIRECTIONAL hum which apparently is the kind of hum this can fix. Fortunately that's the only noise malady they suffer and it's weak...

[johnallg]

1) Pick a point - probably centrally located - wherever it is easy to reach.

2) The treble cavity becomes a complete enclosure of it's own, grounded by the black eyelet ground wire on the height adjustment screw.

[cassius987]

2) The treble cavity becomes a complete enclosure of it's own, grounded by the black eyelet ground wire on the height adjustment screw.

So solder from the copper shield to the eyelet with a short wire?

[johnallg]

2) The treble cavity becomes a complete enclosure of it's own, grounded by the black eyelet ground wire on the height adjustment screw.

So solder from the copper shield to the eyelet with a short wire?

You could, or let the copper overlap the top a tad and the surround will contact it when screwed down.

[cassius987]

You could, or let the copper overlap the top a tad and the surround will contact it when screwed down.

... Duh!!

Thanks John.