Mike,
I purchased (for a number of RRFers) replacement screws that drop right in the holes on the new high gains. I haven't done the mod yet but if any of the others will chime in and vouch for its success, I will send you some of my left over stock. It will save you the dremel step.
High gain/VP conversion
Moderators: rickenbrother, ajish4
-
jingle_jangle
- RRF Moderator
- Posts: 22679
- Joined: Wed Dec 22, 2004 6:00 am
- Contact:
Re: High gain/VP conversion
If they drop into the holes, they're too small. They must thread into the holes. 
Re: High gain/VP conversion
jingle_jangle wrote:If they drop into the holes, they're too small. They must thread into the holes.
drop in = thread