Truss Rod Tool

[dwinn]

This might sound funny, but does anyone have a Truss Rod wrench I can borrow? I'll pay for shipping and send it back to you. Lemme know. Thanks

[beatlefreak]

Daniel, go on-line to some tool companies and order one. What you want is an Xcelite L-8 long shaft 1/4" nutdriver. You can find 'em for $7-8.

[beatlefreak]

Here's one source:
https://weldwarehouse.securesites.com/c ... :number=L8

[jps]

Yeah, cheaper to by than to borrow!

[cassius987]

Yeah, cheaper to by than to borrow!

+1

[jps]

Yeah, cheaper to by than to borrow!

+1

Of course, I meant to say "to buy"!

[cjj]

Good save! Luck for you, the Curmudgeon/ Homonym Police Chief is off vacationing with JH for a few days...

[jps]

How about:

"cheaper to buy than to burro"

[fatcat]

I've found that my 6 1n 1 screwdriver works if I remove one of the reversable bits.And it has a deep socket.

[collin]

If you buy one, you might want to make sure you have a bench grinder too.

The one I got had sides that were far too chick to fit in the route, and grab onto the nut. I had to grind away at the sidewalls of the socket until it would fit in. Works great though---order the $8 tool!

[ricaddic]

You can get the same tool at home dept or lowes, for around $5.00